Bit late now, the chain saw may have done its job, but on the 461 the compressor is in the bilge adjacent to the cooker area. Download Free Software Nokia Service Tool V1 .0 more. Secondly a tool I can heartily recommend for this sort of work, link below. I use this for any fine joinery job where a thin controlled cut is needed, it is absolutely brilliant. The good thing about it is you can start at any point and go in to any depth, cut out the shape you want and no extra saw kerf around the sides. FINE also do one, but out of my budget.

The new (to me) Beneteau 325 has an Isotherm 3000/3500 fridge, circa mid 90's. The unit started life as Isotherm 4200 ASU water cooled unit. My manual for a 4201 which is a BD50 water cooled unit but I think uses the same type of switch says the following about the lights (if you do not have a manual. We have the standard isotherm fridge (Mod no. 3135FA2B0000, R134A) with top and front door and it. Check your instruction manual or go to - this explains that the refridgeration will work with the seacock closed, but only to a very limited. The Isotherm 3000/3500 'kit' has an air cooled compressor and there are no cooling pipes running from the installation to any skin fittings.

There is also a similar unit made by CEL (see Amazon) but I don't know how good it is. Good luck, Graeme. Thanks Graeme, the job is done, the mistake is found. The cable connector which lay under the compressor in the bilge (!) was corroded (it should have been hung up) The ugly part part was the sawing and now we will have to put a mahagony playwood cover over it. Thanks to the fast response of Hanse After Sales we knew on which side to drill. The electrician doing the job couldn't believe his eyes that Hanse forgot to make this inspection door.